Replacing an Audi A3 car radio antenna is something. Audi vehicles come with an antenna which is built into the windshield.
Things you’ll need:
- Portable drill with drill bits (elective)
- Ratchet set
- Philips screwdriver
- Regular (flat head) screwdriver
- Wrench set
- New car radio antenna
Step 1: Determine Car Stereo Antenna Kind
Some auto radio antennas are repaired. This means that they don’t have the ability to retract or extend. The automatic type of car stereo antenna is further divided into types, the first being motorized. This type of automobile radio antenna extends and retracts using cable and a motor, and requires a bigger number of space and an electric connection. The following kind is vacuum controlled. This type will have a cylinder that’s attached to a vacuum line. It may be necessary to remove a panel of interior covering to expose the antenna body when determining the car stereo antenna type. If you’re unsure, check your owner’s manual or Audi dealership, or
If you have determined that you have a model that is motorized, you must first disconnect the battery cables. Disconnect the car radio antenna by unplugging it from the antenna housing. Identify and unplug the electrical cables or the vacuum line from your antenna housing. You’ll just have to unplug the car stereo antenna cable if you’ve got a fixed antenna. Using the appropriate tools, unbolt the car radio antenna from the body of Audi. Take note of and be cautious not to distort or deform the antenna seal situated on the outdoor side of the antenna mounting. When mounting the new antenna you need to keep this seal in good condition in the event you need to use it. Take note that if you install the antenna that is new without the seal, water will leak into the Audi vehicle. You can get more information visit-
Step 2: New Antenna Setup
If you’re replacing an antenna that’s built into the windshield, you will need certainly to locate a spot inside the luggage compartment of the Audi vehicle to mount the aftermarket car antenna. A hole should be drilled through the body of the vehicle bolt it into place and in order to fit the antenna. If you intend to use a motorized model, you’ll have to run electrical cables from the fuse box to the antenna. Reverse the process outlined in step 2 above if you’re replacing an existing body mounted auto radio antenna.
Repairing or replacing a car stereo antenna is a job that practically anyone can perform at home. With a bit of time and a minimum of tools, you can complete a task that you can be proud of.